How to use Elimax® shampoo?
In children the solution must be applied by an adult or under adult supervision.
Close the bottle tightly after use and wash your hands.
STEP 1: Apply the shampoo to dry hair
Place a towel over your shoulders and neck to protect your skin and clothing. Apply Elimax® shampoo directly to the scalp with
the help of the applicator. Make sure that the shampoo completely covers all hair and scalp. Massage well from root to tip, with
pay special attention to the area behind the ears and the hairline on the back of the head. Leave on for 15 minutes without covering your hair. In case
with long hair, pin the hair up.
STEP 2: Wash your hair
Apply the shampoo, adding the minimum amount of water sufficient to foam. Rinse thoroughly with water.
The product is easier to rinse with warm water. Take care that the product does not get in your eyes.
It is not necessary to wash again with your usual shampoo.
STEP 3: Comb your hair
Comb your hair carefully with the Elimax® fine-toothed lice comb after washing your hair, it will further increase the effectiveness of shampoo application.
• Untangle the hair with a normal comb or brush.
• Then, comb wet hair with the Elimax® lice comb.
• Divide the hair into 4 sections: from the forehead to the nape, after one ear to the other.
• Treat each section by isolating small locks so that the scalp is visible.
• Comb each strand, always starting as close to the scalp as possible. Always comb from the top of the head down.
• Using the comb, remove any lice / nits you find. Separate the locks free of lice / nits.
• After combing each lock, clean the comb with a tissue.
It is recommended to dry your hair with a towel, as using the dryer may cause irritation on the scalp. Check the hair after 7 days. In most cases, a single application is sufficient. However, if you still check for lice, repeat the application.